| Quill Work |
|
|
|
|
Using the quills of the porcupine, this intricate art is used to decorate hide, fabric, and birchbark. ![]() After the quills are pulled, they are washed in hot soapy water. It takes at least five changes of water to remove the natural grease. Once cleaned, the rinsed quills are spread out on towels to dry. Medium and large quills are collected and sorted into separate piles, while damaged quills are thrown away. The large quills are used mainly for jewelry. Small bundles of medium quills, about one inch in diameter, are soaked in warm water for five minutes to soften the quills and then dyed. Large bundles of quills do not dye evenly. ![]() Nowadays, quills are coloured using commercial dyes. Before commercial dyes were available certain vegetation was relied on to acquire the desired colours.
Years ago only water was used when dying quills, sometimes the water was made acidic by boiling currants or gooseberries. This would help prevent the colours from fading. Dock root was also added to produce brighter and stronger colours.
![]() Each quill must be softened again just before it is used. Quills are made pliable by placing them in a damp cloth, or in the mouth to allow the natural action of saliva to soften them. Make sure the barbed end of the quill is facing out. There are several things to note when looking at a piece of quillwork. The quills should be shiny, indicating they have not been damaged. Rows of quillwork should be even and black quill ends should not be visible unless they are part of the design. |











Quill Work




